Trigger Guard - FCD
Winter on left, straight on the right.

Trigger Guard - FCD

review
0
0
5
Your Price: $20.00
In Stock.
Part Number:FCD-TGF

Choose Options

Choose
TGF (Trigger Guard, Forward Controls) is available in standard (straight) and winter versions. Both are machined from 7075 aluminum, they do not have spring loaded detent for the front, but use a set screw like Magpul's, and a standard trigger guard roll pin in the rear.

Both versions feature a canted front edge to make rocking the magazine into the mag well easier. The winter version has as much constant/unchanged space from the trigger bow forward as possible (instead of of the space inside tapering and decreasing as the trigger guard nears the receiver's front trigger guard holes). The space to the rear of the trigger bow is inaccessible for the user's finger, so it's kept small and low. This allows the hand to remain higher on the grip than any other enlarged trigger guard available.

TGF is designed for use with TDP spec forged lower receivers, and fills the gap forward of the pistol grip, between the trigger guard "ears" (note that TGF will not swing down like TDP spec trigger guards).  All the sharp edges and corners have been removed.    Due to the variations and tolerances of forged receiver forgings, fitting might be required for receivers too far from TDP dimensions and tolerances. 

Lower receivers made from Cerro Forge "keyhole" forgings generally have taller trigger guard ears, as do Colt, LMT, and BCM lower receivers. 

TGF is proudly designed and made in the USA.   A trigger guard roll pin and set screw (for the front) are included. A common 1/16" Allen wrench is required (not included).