OPF-G, RMR (Optics Platform, Glock, for RMR) is a Glock MOS Adapter
Set 01 compatible plate for mounting Trijicon RMR or SRO on Glock Gen 4
and Gen 5 slides, G17, G19, G34, G35, G41 (width 25mm/1 inch.) It is
incompatible with G40 that uses Set 02.
like the Glock MOS concept, even if we find the factory MOS adapter
plates could use some help. Standards, commonality, availability of
parts are all good things. Heretofore, users have had to send in their
slides to be milled to accept mini red dot sights, or opt for 3rd party
optics ready slides. The time it takes to send in the slides to be
milled, and varying quality of the milling work and optics ready slides
notwithstanding, there was a lack a standard regarding the sight height,
it'd be a coincidence if two slides milled by two different shops share
the same sight height. Glock's MOS may not sit as low as some, but in
our opinion, what MOS offers more than makes up for it, namely a
uniform sight height, ease of installation, parts commonality and
OPF-G, RMR is a collaboration
with a USMC combat veteran and former USMC Shooting Team head coach,
Tom Shields. We used Glock's MOS adapter plates as a basis, and designed
our version of what we think it should and can be.
OPF-G, RMR's shape follows its functions, same as all of our products. We outlined the following objectives:
1. Sight is to be fully supported in the front and rear by recoil lugs/fences, with minimum movement.
2. Eliminate the need to use an additional sealer plate.
3. Correct length sight to plate, and plate to slide screws. Screws are to be Torx.
4. Adapter plate is to be machined in steel.
RMR accomplishes all of the goals outlined above. OPF-G, RMR's
thickness is unchanged from that of the Glock MOS plate, it doesn't
change the sight's mounted height, nor does it require different iron
Trjicon RMR and SRO share the same mounting footprint, OPF-G, RMR is
also compatible with SRO.
Trjicon RMR and SRO share the same mounting footprint, OPF-G, RMR is also compatible with SRO. However, due to the precise fit of the front and rear recoil lugs/fences that are designed to closely sandwich the sight, OPF-G, RMR is not guaranteed to work with all Holosun sights.
OPF-RMR is shipped
with plate to slide screws (M3-0.5mm x 6mm, same as what Glock MOS
plates uses), and sight to plate screws (6/32 x 3/8), a T10 key and a
Plate to slide torque value: 13 to 15in/lb
Sight to plate torque value: 13in/lb
Proudly designed and made in the USA.
NOTE: this version is incompatible with G40 (10mm) that uses Glock MOS Adapter Set 02.
RMR is designed to sandwich the sight in its front and rear fence, we
make the spacing as close to Trijicon's dimensions and tolerance as we
can. Though we hold a 0.003 tolerance, Trijicon's estimated tolerance
is 0.005. In practical terms, this means while some RMRs will move
inside the fences by a very small amount, others will need to be forced
into the space.
Vibra-tite also provides a video on the application of VC-3: https://www.vibra-tite.com/portfolio-items/vc-3-threadmate-overview-video/