Containing switch wires has always been a struggle, with traditionally weak/temporary materials being used from zip ties that can melt or snap, to elastics that can stretch out or snag on things as well. The Arson Machine WireGuide wire retention system starts with the M-LOK system to give it maximum
versatility. From there 3 separate orientations of the system were created to
allow for unparalleled routing and securing options.
The first and most
basic of the three is the Thru Guide. This has 2 channels to
feed wires parallel to the M-LOK slots. This is the work horse of the
system. You can use multiples of these to both route as well as secure
your excess wires in line to the back of your light.
Next is the Right
Angle Guide. It’s main
purpose is to take the wire and do just like it’s name implies, and turn
the wire 90 degrees. This way if you are running a switch on your top
rail you can bring it off the 12 O’clock and tie it inline, behind your
light with ease. It can also be used as a perpendicular pass through.
The last piece to this puzzle is the End Guide. This clamp’s main
purpose is be used to stylishly pull the slack out of the wire if need
be so that it becomes less of a snag hazard. The wire comes in, does a
full 180 and comes out in the same direction that it comes in, making a U-Turn in your wire line.
The Arson Machine WireGuide System is every bit as modular as their light
mounts and just as easy to use giving you many possibilities for
cleaning up your handguard. You can use any number of the clamps in
unison to create an ideal, personal solution to the wires used on your gun. When combined, any 2 parts can sit in (1) M-LOK slot if
needed. You can also place a single clamp anywhere with in the slot
which allows for the maximum flexibility in your set up.
All three
Guides are made of domestically produced 6061-T651 aluminum that is Type
III hard anodized in black for maximum longevity and durability. There are some added subtle Grip Rings on the top surface of each part to
help with grip and help reduce visual signature.
SOLD INDIVIDUALLY - mounting hardware included, you'll need your own 1/8" allen wrench/hex key to install.
